A sample is the cheapest insurance a towel buyer can get. It shows what the supplier understood from your brief and what the bulk order will look like. Yet many buyers glance at a sample, feel it once, and approve it. A proper evaluation takes an afternoon and a washing machine, and it can save an entire order.

1. Check it against the specification

Put the sample next to your written specification and go line by line.

• Size: measure length and width with a tape. Note the figures.
• Weight: weigh the towel on a kitchen or postal scale. Divide the weight in grams by the area in square metres to get the GSM, and compare it with what you asked for.
• Colour: compare with your reference in daylight, not only under shop or office lighting.
• Border and design: confirm the style matches the brief.

2. Look closely at the construction

• Loops: the pile should be even and dense, with no bare patches and no long, loose loops.
• Hems: the stitching should be straight and secure, with no loose threads at the corners.
• Edges: the sides should be straight and firm.
• Surface: look for pulled threads, stains, or uneven dyeing.

3. Test absorbency

Lay the towel flat and drop a little water on the surface. On a cotton towel it should sink in quickly instead of sitting on top. Some new towels carry a finish that slows absorbency until the first wash, so repeat this test after washing.

4. Wash it, more than once

This is the test that matters most. Wash and dry the sample at least three to five times, the way the towel will be laundered in real use. After that, check:

• Shrinkage: measure again. Some shrinkage is normal for cotton, but the washed towel should still meet the size you need.
• Softness: does it still feel as it should?
• Colour: has it faded? Did it bleed onto other items?
• Lint: a little lint in the first washes is common. Heavy, continuing lint points to weaker yarn.
• Shape: is the towel still square, or has the border puckered or the hem twisted?
• Loops: have threads pulled out during washing?

5. Inspect the branding

If the sample carries your logo, check its size, position, and colour against your artwork. Embroidery should be neat, with no loose stitches, and should not pucker the towel after washing. A jacquard design should be clear and correctly placed.

6. Check labels and packing

Confirm that the care label states the correct fibre content, care instructions, and origin, and that it meets the rules of the market where you will sell. If you asked for particular packaging, review that too.

7. Give clear feedback

If something is not right, say exactly what and by how much: "length is 2 cm short", "shade is darker than the reference", "logo should be 1 cm higher". Vague feedback produces a second sample with new problems. Ask for a revised sample where the change is significant.

8. Approve in writing and keep the sample

When the sample is right, approve it in writing and note any agreed tolerances. Keep one approved sample yourself, and ask the supplier to keep one. That sample is the reference for bulk production and for any inspection before shipment.

A simple checklist

1. Measured and weighed against the specification.
2. Construction inspected.
3. Absorbency tested.
4. Washed and dried several times, then re-measured.
5. Branding, labels, and packing checked.
6. Feedback sent, or approval given, in writing.

At Mansa Exim International, every order begins with a sample made to your specification, confirmed with you before production starts. See our towel range or request a sample quotation.